Maryland’s economy and culture rely on the Chesapeake Bay Watershed. In the 2025-2026 winter season, the Maryland Department of Transportation reported rock salt in 87 salt facilities (386,000 tons) and salt brine at 77 sites (1.6 million gallons). These salts were the materials available to the Maryland State Highway Administration (SHA). Runoff from salt-applied roads carries chloride into the waters that Chesapeake communities depend on. In Maryland, salt damages 28 watersheds, impairs water quality, endangers native species, and pollutes drinking water.

Maryland’s road-salt regulations fail to prevent chloride impairment, so the state should require targeted use of Calcium Magnesium Acetate (CMA) through MS4 permits in chloride-damaged watersheds.

The Maryland Department of the Environment (MDE) identifies chloride as a threat to the state’s waterways. Current regulations address chloride runoff but remain insufficient to prevent water-quality impairment. Chloride is a nonpoint source of pollution that contaminates drinking water. Road salt pollution implicates the Code of Maryland Regulations (COMAR). COMAR notes toxic substances may not pollute state waters and harm human or aquatic life. However, chloride already threatens waterways and affects public health.

Phases I and II of the Municipal Separate Storm Sewer System (MS4) are supposed to provide a mechanism to prevent chloride pollution. But the permits leave a regulatory gap.

Phase I Salt Management Plans (SMPs) seek to protect water-quality standards under the Clean Water Act §303(c). SMPs focus on how jurisdictions apply and reduce road salt.

However, compliance with these measures does not guarantee reductions in downstream chloride levels. Municipalities can satisfy permit requirements while waterways remain chloride-impaired.

Phase II MS4 permits promote Best Management Practices (BMPs) that should protect local waterways. These permits are designed to put COMAR standards into practice. COMAR should protect water quality and public health. But Phase II regulations are not enough. They regulate stormwater practices, not downstream chloride concentrations.

CMA would meet Phase I and Phase II MS4 permit requirements by protecting water quality standards through salt management plans and complying with BPM. If Phases I and II require municipalities to use CMA, it would comply with COMAR goals of protecting the environment, drinking water, and public health.

Road salt increases salinity in surface and groundwater. Elevated chloride concentrations persist in groundwater and soil, causing long-term stream salinization. Maryland’s Water Quality Assessment notes chloride as “impaired and require a Total Maximum Daily Load (TMDL).” A TMDL is the legal amount of pollution water can have while still meeting state and federal water quality standards. A TMDL allocates pollution burden among “nonpoint sources…such as runoff from roads.”

TMDLs establish a benchmark of acceptable chloride pollution, but any amount of chloride pollution is too high. Maryland should strive for zero road salt use, not hitting the benchmark. TMDLs do not explain why pollution levels are acceptable and establish a target without a strategy to lower chloride.

MS4 permits require Maryland to reduce and track road salt use. Managing salt application under this regulatory framework does not work if TMDLs are too high. The Department of Natural Resources identifies that chloride concentrations would increase, even if usage halted. The MDE recognizes that consistent chloride reductions “will likely take many years.” Maryland reports that road salt can remain in watersheds for 40–70 years. Even if salt application stops, accumulated chloride can continue polluting waterways for decades.

Reducing chloride pollution begins with lowering TMDLs and increasing CMA.

Maryland needs regulations that reduce salt use while protecting road safety. CMA can maintain public road safety without chloride. Agricultural corn waste can produce CMA. Maryland could trigger CMA implementation via water-quality controls under existing CWA

Maryland should require targeted CMA use in areas with high chloride risks. This approach reduces chloride pollution while maintaining public road safety and ensuring a smooth transition between systems. Less chloride means cleaner and safer water.

Compared to chloride products, “acetates are expensive, but cause minimal damage to roads, vehicles, and vegetation.” However, CMA can deplete dissolved oxygen as microorganisms break down acetate. At 2°C, CMA takes 100 days to decompose in water compared to four weeks in soil.

CMA prices would increase the winter maintenance budget exponentially, so Maryland is hesitant to make the change. Taxpayers, however, should want CMA because it protects ecosystems and reduces long-term hidden costs like vehicle corrosion and accidents. After switching to CMA in 1994, Oregon noted that it has “proven low-corrosion properties and is considered safer for the environment.” Oregon’s TE28 anti-icing study reported no accidents in a liquid CMA test area during a two-and-a-half-day storm.

Road salts should not be substituted for CMA, but a transfer from road salts to CMA in chloride-damaged watershed areas is the solution.

By switching to CMA in vulnerable areas, Maryland could pursue a well-tested and financially feasible approach to reducing chloride in groundwater and protecting the Chesapeake Bay Watershed.

Hayden Haber is a Kent County native and studies environmentalism at WIlliams College’s Zilkha Center for the Environment.

AI Disclosure: The Spy and its writers may use artificial intelligence tools to support accuracy and clarity in our reporting.

Write a Letter to the Editor on this Article

We encourage readers to offer their point of view on this article by submitting the following form. Editing is sometimes necessary and is done at the discretion of the editorial staff. Your email address will not be published. Required fields are marked *